To transfer a saved file into the EasyBAC, have the EasyBAC attached to your PC either directly using a crossover cable or via a hub.

If the EasyBAC is at the factory default IP address of 192.168.0.14, change the IP address of your PC to match the IP subnet of the EasyBAC i.e. allocate your PC an IP address like 192.168.0.100 with a subnet mask of 255.255.255.0.

Once the IP Address of your PC is configured, start the VOC program and open the file you intend to transfer followed by going to File | Transfer. This will open a new window called "Transfer Virtual Objects". The IP address of the EasyBAC is listed as the default of 192.168.0.14 leave it as is if it is correct. If it is not correct, please change it to the correct IP address.

The username and password are both the same and it is "manu" (case sensitive) without the quotes. clicking on "Start" will transfer the file into the EasyBAC. Upon completion, you will see a message that indicates a success or failure.

If you see any other message other than "Success", check your connections and the username and passwords.