- Home
-
BACnet
- Product Solutions
-
Category/Products
-
BACnet Development
- B1050 - BACstac Software for Projects
- B1060 - BACnet Software for Windows
- B1090 - BACnet Software for Windows (source)
- B1140 - BACnet Software for Embedded Systems
- B2110 - BACnet MS/TP Interface
- B5001 - BACnet Discovery Tool
- B5020 - BACnet Protocol Analyzer
- B6090 - BACnet to Microcontrollers Software
- BACnet Installation Tools
- RS-485 Networking
- BACnet ICs & Modules
- BACnet Relays & Sensors
- BACnet Routers
- BACnet to OPC
- BACnet to Utility Meters
- BACnet to Web Services
- Industrial Automation
-
BACnet Development
-
By Part Number
- A1042 - 9-Bit Networking - NBS-42L
- B1050 - BACstac Software for Projects
- B1051 - BACnet Software for Projects (licenses)
- B1060 - BACnet Software for Windows
- B1090 - BACnet Software for Windows (source)
- B1140 - BACnet Software for Embedded Systems
- B2000 - Modbus TCP/RTU Router
- B2100 - BACnet OPC Server
- B2110 - BACnet MS/TP Interface
- B5001 - BACnet Discovery Tool
- B5020 - BACnet Protocol Analyzer
- B6000 - BACnet MS/TP Router
- B6030 - BACnet Interface to Energy Meters
- B6035 - BACnet Interface to Energy Meters (High Capacity)
- B6040 - BACnet Interface to 6 Relays
- B6050 - BACnet Interface to 8 Sensors
- B6070 - BACnet Interface to Pulse Meters
- B6080 - BACnet Interface to Web Services
- B6085 - BACnet Interface to Web Services (High capacity)
- B6090 - EasyBAC to BACnet/IP - SDK
- B6091 - EasyBAC to BACnet/IP - Module
- B6095 - EasyBAC to BACnet/IP - Interface
- BR2-A - BACnet to Trane BCU's (ARCNET)
- BR2-E - BACnet Router Connecting Networks
- Support FAQ
- Support Docs & Downloads
- Support/Info/Quote
- Price List
- Exchange & Return Policy
- Commissioning
- Dashboards
- Submetering - EIS
- About Cimetrics
- Blog
I have configured my Router correctly and I still do not see my devices on the Arcnet network.
Answer
Verify that the cable connected to the Router is a coax RG-62 A/U type. The router should also have external termination with a 93-Ohm terminator. Cable should only be connected/disconnected when the router power if off. Once the cables are attached properly with the appropriate termination, check the BACnet/IP or BACnet/Ethernet settings again (IP addressing, etc.).
