Cimetrics.ru

Create PDF Print

How do I log in to the E+ Device?

Answer

To log into the E+ Device, you would need to connect to the Ethernet port on the product using JUST one PC. If you have a hub, you can connect the E+ and your PC to the hub. If you do not have a hub you could use a CROSSOVER cable to directly connect to the E+. If your PC is set to "DHCP on" (which it probably is !) Then connect your PC to the E+ and the E+ will supply your PC with a proper IP address. Open your browser, enter http://192.168.88.90 and then use “admin” and “admin” (without the quotes) to see the setup screens.

If this doesn't work, then manually set your PC's address to 192.168.88.90 with a subnet mask of 255.255.255.252(or in the same subnet as the IP address you previously programed the E+ to be on) and then open up your browser and type in the IP Address of the router i.e. http://192.168.88.89 or "the IP you set before). The username and password are “admin” and “admin” (without the quotes) unless they were changed during a previous setup.

Category

Eplus - general questions